Jinjiang Shenggong machinery electric tricycle inspection before driving:

Check that the tire pressure is normal, cracks and cuts.

(1) When the inflation is too full (refers to greater than 5 air pressures), the driving will be violently bumpy, and it is easy to blow tires or tire packs in summer;

(2) When the inflation is insufficient, it will affect the driving speed, increase the power consumption, and shorten the mileage;

(3) Tires with cracks and cutouts, tires are explosive. whether the operating system such as brake steering is flexible and effective; Whether the power off device can be powered off before braking.

Brake adjustment method of Jinjiang Shenggong mechanical electric tricycle:

The method of brake adjustment loosens the adjustment nut on the rear brake lever, and when the handbrake is released, pull the rear brake lever forward by hand, and then lift the tire off the ground to release the rear adjustment nut for a distance. The front adjustment nut is twisted and tightened until the brake holds the tire and does not move, then slowly loosen the front adjustment nut, and turn the tire by hand while loosening the nut until the tire rotates smoothly without the feeling of holding the brake. Then adjust the back nut and tighten it. The other brake is adjusted in the same way.

Brake inspection of Jinjiang Shenggong mechanical electric tricycle:

(1) Release the hand brake, when pushing the empty car by hand, the tire should walk flexibly and without hindrance;

(2) Pull up the hand brake, should be able to brake the wheel, push the car hard, the wheel does not rotate is appropriate;

(3) WHEN THE FOOT IS ON THE BRAKE, THE TWO REAR WHEELS SHOULD BE ABLE TO LOCK AT THE SAME TIME (THE BRAKE PEDAL SHOULD BE 3-5CM AWAY FROM THE PLATFORM);

(4) If the above requirements cannot be met, the brake should be adjusted to achieve the above effect, or contact the after-sales service to request technical support.

shoe is worn to 1/2, the brake pad should be replaced to ensure your driving safety, if the brake does not work, it should be stopped immediately, and the power switch can be turned off before stopping, and then go to the relevant maintenance point to repair before driving. After one week of use of the new car, a systematic inspection is required, and all fasteners are reinforced as a whole, especially the brake system must be adjusted twice to ensure safe driving. Check whether the battery power is sufficient, whether the circuit and various electrical accessories work reliably, insufficient charging not only affects the mileage, but also damages the battery life.

The use and operation of Jinjiang Shenggong mechanical electric tricycle:

Vehicle start: turn on the power switch to move the driving button to forward, press the brake pedal, release the handbrake, release the brake pedal, and slowly twist the continuously variable speed handle inward to turn the vehicle inward, that is, start driving slowly.

Vehicle turning: Reduce the speed of the vehicle in advance, turn when it is safe to drive, speed as slowly as possible and increase the turning radius.

Vehicle parking: press the brake pedal to make the car stationary, and then pull the handbrake handle to a reliable position, if the driver needs to leave the vehicle, be sure to remove the key, confirm the safety of the vehicle, before leaving.

Vehicle reversing: press the brake pedal, wait for the vehicle to stop, change the driving button to reverse, confirm that the rear is barrier-free, release the brake pedal, and slowly twist the infinitely variable speed handle inward to reverse the vehicle.